Choosing a garden watering controller that can talk to a smart home, and planning a rain skip so you are not watering a wet lawn. It sits under the irrigation category alongside the existing Smart Mower forum.
Complexity
Controller configuration: beginner to moderate. New 230 V supplies, trenches, or work in an existing irrigation valve box should be planned with the right trades. Check your local water authority for watering restrictions before you automate a schedule.
1. Two common internet-connected controllers
- OpenSprinkler is an open, locally administered irrigation controller. The official site covers ready-made controllers and a firmware/API you run on your own hardware. There is no official built-in Home Assistant integration at the time of writing; community integrations exist (commonly installed via HACS). Treat those as community software: read the project page, check the current version, and do not confuse them with a core integration.
- Hunter Hydrawise is an official Home Assistant integration. Official docs list Pro-HC, HPC, HCC, X2 with the WAND module, and the discontinued but still supported HC. Rain sensors and flow meters connected to the controller are supported. Setup uses an account at app.hydrawise.com and an API key from Account Details. This path depends on Hydrawise's online service.
OpenSprinkler is attractive if you want the schedule to keep running on the controller even when a cloud account is unreachable, and to drive it from Home Assistant on your LAN. Hydrawise is attractive if you already have that Hunter controller and want official Home Assistant entities for zones, water use, start/stop and pausing the automatic schedule. Official Hydrawise docs also mention tracking garden water use on the Energy dashboard.
3. Sensors worth planning
- A rain sensor or a weather-based skip (Hydrawise documents rain sensors; Home Assistant can also use a local rain sensor or a weather integration).
- A flow meter, if you want to notice a stuck valve or a burst line.
- Soil moisture, if you are watering beds rather than running a simple program.
Many domestic valves are low-voltage solenoids powered from the controller. The controller's own 230 V supply, outdoor cabling and any new circuit still need to comply with Australian installation rules and be done by a licensed electrician where the work is electrical work. See also the electrical-compliance guide in Site News. Valve boxes, backflow and the irrigation hydraulic design are not "smart home" tasks — use an irrigation designer or plumber where the job is more than a like-for-like controller swap.
Hardware cost
Controllers, valve wires, rain sensors and transformers should be quoted in AUD for your number of stations. OpenSprinkler publishes its own store prices, but landed Australian cost, GST and compatible accessories still need a current check, so this introduction does not freeze a number.
5. Next step
The project thread in this forum walks through a Hydrawise official integration and the official "skip watering when it rains" idea, and notes how an OpenSprinkler owner can aim for the same behaviour locally.
Official reading
OpenSprinkler
Hunter Hydrawise for Home Assistant
Hydrawise account / API key
Researched from official documentation on 15 November 2026 (Australia/Sydney). This is a planning and how-to guide, not a claim that the exact hardware combination was assembled and tested on a live site. Please correct anything that has moved on.