A map of where to look when a smart-home job touches electrical work in Australia. It is not legal advice, not a substitute for a licensed electrician, and not a quotation from AS/NZS 3000. If a fact matters for a real job, read the current official page or ask the electrician who will certify the work.
Complexity
Reading: beginner. Doing the electrical work itself is licensed trade work.
1. "Smart" does not make it extra-low-voltage automatically
A Wi-Fi relay in a wall box, a new lighting circuit, a switchboard surge protector, or an outdoor irrigation controller supply is still electrical work when it is electrical work. Low-voltage bus wiring (C-Bus, KNX, DALI) can also be installed under rules that the electrician will apply on site. When in doubt, treat it as electrical work until the electrician says otherwise.
2. Licensing is state and territory based
Electrical licences are issued and checked through each state or territory regulator. ERAC's licensing page is a sensible first bookmark for the state and territory regulators, then follow the link for your jurisdiction.
In New South Wales (where many Just Smart Homes readers are):
- Electrical work is carried out by a licensed electrician. You can check a licence through Service NSW and at verify.licence.nsw.gov.au.
- A Certificate of Compliance for Electrical Work (CCEW) is the usual completion document. NSW guidance on electrical compliance requirements describes the Certificate of Compliance for Electrical Work and the related eCert process. Ask the electrician to provide the CCEW for the work they did; do not invent one for DIY work you were not licensed to do.
3. AS/NZS 3000 is cited by reference, not quoted here
AS/NZS 3000 (the Wiring Rules) is the primary installation standard electricians work to in Australia and New Zealand. This thread does not quote clauses from memory, does not tell you how to size a cable, and does not interpret "fair wear" or "like for like". Buy or access the current standard if you need the text; your electrician already works from it.
Related product standards (for example appliance, luminaire or controlgear standards) also sit behind many "smart" devices. "It works on Wi-Fi" is not the same as "it is approved for this installation method".
4. Solar and batteries have an extra accreditation layer
Choosing a solar retailer and installer is described by the Australian Government at energy.gov.au. Since 29 May 2024 the solar installer accreditation scheme has been operated by Solar Accreditation Australia (SAA), not the former CEC scheme. Inverters, export limits and battery work remain professional installation — see the solar forum.
5. A practical checklist before you automate a circuit
- Is this electrical work? If yes, a licensed electrician does it and issues the local compliance certificate.
- Is the device approved and used in the way the manufacturer describes (in-wall, outside, on a lighting circuit, and so on)?
- Have you left a way to operate the light or load if the hub, VLAN or Wi-Fi is down?
- Are you changing a safety function (RCD, smoke alarm, emergency lighting, isolation)? Stop and use a licensed electrician — those are not "home assistant" projects.
ERAC licensing
Service NSW licence check
NSW licence verification
NSW electrical compliance requirements
energy.gov.au solar installers
Researched from official documentation on 15 November 2026 (Australia/Sydney). This is a planning and how-to guide, not a claim that the exact hardware combination was assembled and tested on a live site. Please correct anything that has moved on.